Garden Light Control System .
One receiver comes with 2 transmitters.
The radio control units included in the pack are already programmed andr eady to use. Zones1 and 2 can operate independently in bistable or timed mode.
Setting the mode of operation:
BISTABLE: Remove the jumper on terminals1and 2
TIMED: Insert the jumper on terminals1and 2
BISTABLE: Remove the jumper on terminals2and 3
TIMED: Insert the jumper on terminals 2 and 3
Radio control acquisition:
1. Press keyP1 on the control unit once to program exitZ1; The LED will remain on.
2. Press and hold the key to be acquired on the radio control unit until the LED on the main control unit starts to flash; Release the key.
1. Press key P1 on the control unit twice to program exitZ2; The LED will remain on.
2. Press and hold the key to be acquired on the radio control unit until the LED starts to flash; Release the key.
Setting the work time: (time the exitison)
Only if TIMED MODE is used
Press keyP2 on the main control unit once to set the work time for exitZ1, the LED will set on exitZ1, after which press key P2 again. The LED will flash three times to confirm.
Press keyP2 on the main control unit once to set the work time for exitZ2, the LED will come on.
Wait a length of time equal to the WORK TIME to be set on exitZ2, after which press key P2 again. The LED will flash three times to confirm.
Delecting the radio control codes:
Deleting an individual code:
Press and hold keyP1 on the main control unit for 5 seconds (release the key); The LED will remainon. Press the key on the radio control unit to be cancelled until the LED begins to flash.
Deleting all codes:
Press and hold keyP1 on the main control unit for approx. 10 seconds, the LED will come on, then release the key. The LED will emit 3 flashes to confirm the deletion of all the codes.
Cee declaration of conformity:
Garden Easy Light,
Is manufactured for the remote control of external electrical devices;
Conforms with the following standards:
Notes for installation:
WARNING! It is important the following manual be followed for safety reasons. Incorrect installation
Or improperuse of the product canlead to severe damageto property and /orpersons.
The packaging materials should be kept out of the reach of children since theyare potentially hazardous.
The Easy Garden Light mustonly be installed by aqualified installer.
Do not modify the device in anyway.
Disconnect the power supply prior to any intervention on the system.
Fit a bipolar switch to the device power supply (Use of amagne to thermal device with omnipolar switching is recommended).
Check that a differential switch with a threshold of 0.03 AIS installed upstream of the device.
Do not install the equipment in anex plosive atmosphere: The presence of flammable gas or fumes constitutesaserioussafetyhazard.
The status of the system has a direct influence on the reliability and safety of the device.
Anything not expressly envisaged in these instructions is not permitted. Store the instructions for future reference.
Ensure the device is not connected to the power supply before opening the cover hatch on the casing in which it is contained.
THE INFORMATION CONTAINED IN THIS INSTALLATION MANUAL MAY BE SUBJECT TO CHANGE
WITHOUT PRIOR WARNING.